EIO'S control panel for outdoor use high-power solar charger for 6V, 12V lead-acid battery charger automatically load protection and protection of the discharge. Load can be connected LED, light bulbs, and so on. With infra-red remote control, enables a variety of LED lighting and so on.
The use of battery: 6V or 12V7A and other specifications.
Maximum load power: 200W.
Remote distance:> 10 meters.
EIO'S double switch bright searchlight battery panel, you can control enough power 25W bulb, the structure of the double switch, the switch to avoid damage to the shortcomings of a switch to turn off the light to do an independent action. Panel and the panel to adopt the design of the installation of separation. Other features and performance, see 9000 General searchlight-board and IC.
Http://www.eio.com.cn/NEWS1/html/2008-6-1/200861153247.htm
Profile: EIO'S new LED lights use emergency fire microcomputer (MCU) control, power outage in the light automatically after 21 high-brightness white LED emergency lighting, lighting time up to 2 hours. When there under-voltage battery when it shut down automatically LED. When the electricity back to the time, the closure of LED lighting and automatically enter the charge until full.
This product is a feature of the largest power outage if the daytime, it will not open the LED lighting, wait until the evening before opening to avoid blackouts because of morning, to the lighting at night can not be achieved! This product is the general emergency lights a fire added products.
Scope: hotels, restaurants, hospitals, families need emergency lighting, and other occasions. Is particularly suitable for the same place, scattered over the use of fire emergency lighting.
Profile: EIO'S double switch-glare lighting control panels, and independent control of LED bulbs, particularly in the electricity shortage can also open an independent LED continue to use a few hours. Other stalls directly by LED switch can immediately shut down, other basic functions of the same general profile 3. Switch failure rate low.
Function: K1 switch the bulb stalls, click Close bulbs, cut off, click open LED.
K2 control and poor light, bright lights, blinking light and close the lamp, a total of three stalls.
Other features and performance of 9000-see the general board and IC searchlight information.
HOLTEK MCU program to control the three primary colors ultra-high brightness LED brightness cycle gradually, reaching changes in the colorful effect.
As a result of current source and the source of regulators, even if the power supply from 5V-9V changes in the brightness of the LED completely unchanged.
The use of power: DC 5V-9V
Current work: constant current regulator
